80mm opening should fit any single battery clockworks. Glue dial to disk, glue clockworks to back of disk, glue assembly to clock body Support is required on this print.. Finished model was painted with gold spray paint. Printed in ABS @.3mm, 2 perimeters, two tops, two bottoms, 20 percent infill. Note: Disk has been modified to fit better, thanks to ElmoC. Note: Ran out of filament at the end of print, only a few layers left, so I stopped the print, and that accounts for the open face on the base.
Thanks to noisekid for the male and female guardian lions..