PLEASE , load the stl-files separately. The zip-file download does not work.
This is a case derived from my universal case. It holds the TinyfabXY heated bed controller and driver. Helps fighting the mess with floating wires a little better.
The pictures (top part V1) directly linked: https://thingiverse-production-new.s3.amazonaws.com/assets/ab/e3/bf/a8/16/Tinyfab_heatcontroller_case.jpg https://thingiverse-production-new.s3.amazonaws.com/assets/28/08/f5/58/b1/tinyfab_top_case1.JPG https://thingiverse-production-new.s3.amazonaws.com/assets/79/10/e8/91/d0/tinyfab_top_case2.JPG
- case top with / without opening for the cable - case top with / without opening for the screws topside - case lower part - clamp bar for cable strain relief
The top part fits ok. It could be used with the controller pcb allone.
Take care about insulation between the parts pins and a metal surface you screw it on. Put a sheet of plastic or some insulation tape inbetween at least.
The pcb with the display and rotary encoder could be brought up a little more. But this would require to make a cutout for the rotary encoder body. The LED display a few mm below the level given by the rotary encoder body. IMHO this is a design flaw.
The lower part fits the driver board. A.t.m. i'm using an earlier made unpolished part. Not for showing off.
Have not put in the openings for the cables / wires to the bottom case. Probably I will take the cordless drill. The easy way.