Film holders for dslr scanning 35mm 6x6, 6x7, xpan (4912155)
Item Preview
There Is No Preview Available For This Item
This item does not appear to have any files that can be experienced on Archive.org.
Show all files
These are film holders for scanning with a dslr or mirrorless camera with a macro lens. A phone or light table and a repro stand are needed to complete your set-up. The curved film path keeps the film stable and flat at the film gate of the adapter.
Printing:
This was printed in PLA 0.2mm layer height at 200 degrees with a heated bed at 60 degrees. Calibrate your e-steps for this print as the film path is narrow and overextrusion will clog it up.
Make sure to put the Z-seam left or right, so that the film path is printed in a single conitinuous motion without stops. This helps to ensure that the film will move through smoothly.
You need to print 2 copies of a design and then bolt these together with m6 or m8 bolts.
Printing times depend on your print speed bu vary from roughly 6-10h per half.
Printing:
This was printed in PLA 0.2mm layer height at 200 degrees with a heated bed at 60 degrees. Calibrate your e-steps for this print as the film path is narrow and overextrusion will clog it up.
Make sure to put the Z-seam left or right, so that the film path is printed in a single conitinuous motion without stops. This helps to ensure that the film will move through smoothly.
You need to print 2 copies of a design and then bolt these together with m6 or m8 bolts.
Printing times depend on your print speed bu vary from roughly 6-10h per half.
Reviews
There are no reviews yet. Be the first one to
write a review.
