In the middle of the board, horizontally, you have **2 holes for M4 bolts** to use as handles. Use the length you prefer, I went for *M4x30mm* in my case because it was the only bolts I had around, but if you want to stay close to the original length, **I recommand M4x8mm**
More info here : [Apufix1a product file](https://pcengines.ch/apufix1a.htm) - pcengines.ch website
Use this reusable fixture to allow easy installation of the apu heat spreader in a consistent location.
- Place fixture over front board standoffs (see photo for correct orientation). - Peel protective foil, stick heat spreader in place. - Remove fixture.
*Modeled as a request from a good friend of mine.*